Repair of traction batteries

The UKRSPETSPARTS company offers repair of traction batteries for electric forklifts.

Repair of traction batteries consists of several stages. First, the general condition of the traction battery is diagnosed during which the voltage is measured and the electrolyte density of each battery cell is measured. Depending on the results of the initial diagnosis, a conclusion is made about the further progress of the repair. This can be replacement with new elements or repair of individual elements of the traction battery and the subsequent regeneration of the battery.

Traction battery regeneration is gaining popularity, although the technology itself is hardly new. 80% of batteries fail due to sulfation, which can be dealt with using appropriate equipment. UKRSPECPARTS has equipment that successfully converts lead sulfate into active materials using asymmetric high-frequency pulsation. The chemical process of charge-discharge (including regeneration) of a lead-acid battery is described by the following formula:

2PbSO4 + 2H2O -> Pb + 2H2SO4 + PbO2

The regeneration process restores the battery's capacity, allowing the sulphated batteries to last longer. Also, the use of the regenerator during maintenance can significantly increase the operating cycle due to the prevention of sulfation. The battery regenerator can be used with any lead-acid type batteries: traction and semi-traction batteries, stationary batteries, starter batteries and nickel-cadmium batteries. The cost of this service depends on the condition of the battery.

Repair (regeneration) of a traction battery allows, for relatively little money, to significantly increase the life of your battery and postpone the purchase of a new battery.

No tags for this post.